Full Product Manual

MADE IN CHINA
The Philips trademark and the Philips Shield
Emblem are registered trademarks of Koninklijke
Philips N.V. used under license. This product has
been manufactured by Gibson Innovations Limited.
It is distributed and warranted by Jasco Products
Company LLC, 10 E. Memorial Rd., Oklahoma City, OK
73114. ©2018 Gibson Innovations, all rights reserved.
This product comes with a limited-lifetime warranty.
Visit www.philips.com/support for warranty details.
Questions? Contact us at 1-844-816-0320 between
7:00AM—8:00PM CST.
SPP6463WG/37 v2
2/18
1. Plug the surge protector into a standard grounding
duplex wall receptacle, covering both outlets, by fully
inserting the blades and ensure that there are no
exposed conductors.
2. The surge protector will now be providing power and
surge protection.
3. Make sure electronic equipment is turned o before
plugging into the surge protector outlets. Do not
use extension cords to connect equipment to the
surge protector.
4. Connected equipment can now be turned on.
5. Hold the surge protector rmly against wall when
removing plugs to prevent it from pulling loose.
USB Charging
4.2 Amp total output allows you to charge two tablets
or four smartphones at full capacity at the same time.
Recharge your device at a maximum speed of 2.1 Amp
when connected to a single port.
The USB ports are used to charge portable electronic
devices only. There is no data transfer capability.
NOTE: Check the blue “PROTECTED” indicator light
periodically. A glowing blue indicator light shows
that surge protection is being provided. If the blue
“PROTECTED” indicator light stops glowing, the surge
protective components have expired — though power
will still be supplied to the outlets, now unprotected.
To ensure the protection of your electronics the surge
protector should be replaced.
Surge Protector — Limited-Lifetime Warranty
This surge protector is warranted to be free of defects in
workmanship and/or materials for the life* of the surge
protector. If such a defect should arise during the life of
the surge protector, we will, at our option, either repair
or replace the surge protector without charge. This
warranty does not cover damage caused by lightning,
accident, misuse, or alterations to the surge protector.
* This surge protector, like all surge protectors, has a
nite lifespan. Even under normal circumstances and in
the absence of defects, the product’s life will expire when
the surge protector’s component capacity has
been exceeded, thereby ceasing to provide protection
from surges.
Warranty replacement procedure
1. Call our Customer Information Center at 1-844-816-
0320 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address
label.
2. Return the said surge protector, freight prepaid, to
us. Surge protectors returned to us must have an RA#
included in the mailing address to be accepted.
3. The original purchaser will be asked to send the surge
protector, a copy of the sales receipt for the product,
your name, address, phone number and a description
of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model:
SPP6463WG/37
Maximum Warranty Amount: $50,000(USD)
NOTE: This device is not a lightning arrestor, so it will not
aord protection when lightning strikes nearby power
line, the house, service entrance or antenna. The warranty
is void if a power disturbance damages your equipment
through the coax, phone or network lines.
We will pay up to the maximum warranty amount
oered for the surge protector purchased to repair or
replace up to an amount equal to the fair market value
or the original purchase price, whichever is less, of your
electronics equipment, if damaged by a transient surge
(except those caused by direct lightning), within the
life* of the surge protector, while properly and directly
connected to this surge protector. WE DISCLAIM AND
ASSUME NO LIABILITY FOR ANY OTHER INCIDENTAL
OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT
LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA
OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS
INTERRUPTION OR OTHER DAMAGES DUE TO LOSS
OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA.
Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This
warranty gives you specic legal rights, and you may also
have other rights that may vary from state to state.
This warranty is secondary to any existing coverage of
any connected equipment, including but not limited to,
any manufacturer’s warranty, extended warranties, or
insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be safety certied by a
Nationally Recognized Testing Laboratory.
2. The said surge protector must be plugged into properly
wired and grounded outlets, no extension cords,
adapters, other ground wires or electrical connectors
may be used, with the sole exception of other
standard 120 volt products approved for that use. The
installation must comply with all applicable electrical
and safety codes set forth pursuant to the National
Electrical Code (NEC).
3. Any claim under the warranty policy must be made
within 15 days of the date of the alleged damage to the
connected equipment.
For connected equipment coverage, the following
conditions must be satised:
A. All equipment eligible for warranty coverage must be
plugged directly into said surge protector. Equipment
connected to the protected equipment, but not
plugged directly into the surge protector will not be
covered.
B. The equipment must have been damaged by a covered
power disturbance that passed through the said surge
protector.
C. The said surge protector must be damaged from the
power disturbance.
D. The said surge protector’s protection capacity must
not have been exceeded.
Connected equipment claim procedure:
1. Call our Customer Information Center at 1-844-816-
0320 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address
label.
2. After you have received the prepaid return address
label, return the surge protector, freight prepaid, to
us. Surge protectors returned to us must have an RA#
included in the mailing address to be accepted.
3. We will determine whether the damage to your
equipment is covered by this warranty policy. If you are
covered, a claims adjuster will contact you and we will
do one of the following at our own discretion:
a. Authorize a service center to repair damaged
equipment.
b. Replace damaged equipment with equivalent
or better.
c. Reimburse customer the fair market value of the
damaged equipment.
d. Reimburse customer the initial purchase price of
the damaged equipment (customer to provide
dated bill of sale).
4. We retain the right to determine whether the
damage to the connected equipment is due to said
surge protector failure by requesting that damaged
equipment be sent to us for inspection.
User manual
Home Power
SPP6463WG/37
RISK OF ELECTRIC SHOCK
DO NOT USE IN WET LOCATIONS
KEEP CHILDREN AWAY
USE INDOORS ONLY
FULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL
RATINGS
NOT FOR USE WITH
AQUARIUMS OR OTHER WATER-
RELATED PRODUCTS
• GENERATORS AND
POWER INVERTERS
• MEDICAL LIFE-SUPPORT
PRODUCTS
WARNING
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, USE ONLY INDOORS.
UNIT SHOULD BE PLUGGED INTO AN INTERIOR GROUNDED
PARALLEL DUPLEX RECEPTACLE. NOT FOR USE WITH GROUND-
FAULT CIRCUIT-INTERRUPTER RECEPTACLES OR RECEPTACLES
WITH INDICATOR LIGHTS OR CONTROL. TO REDUCE THE RISK
OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS DEVICE WITH A
RECEPTACLE IN WHICH THE SLOT OPENINGS DO NOT ALIGN WITH
THE BLADES.
FCC Statement
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
FCC NOTE: The manufacturer is not responsible for
any radio or TV interference caused by unauthorized
modications to this equipment. Such modications
could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.

Summary of content (2 pages)