Register your product and get support at www.philips.
What’s in the box SOURCE 1 1 SOURCE 2 SOURCE 3 2 3 SOURCE 4 4 ran Transmitter mitter User manual Quick In tallation Guide Receiver Remote control Power adaptor x 2 Receiver HDMI cable Quick Start Guide Warranty Note • Make sure you have all these items in the box. Contact your dealer for any missing or damaged items.
1 Connect Transmitter Receiver HDMI OUT DC IN 5V DC 5V 2 1 HDMI OUT Connect the transmitter to your HD devices 1 Connect video source to the transmitter using the HDMI cable Connect one end of the HDMI cable (included) to the HDMI connector of the transmitter. 2 Connect the video source to the transmitter using the component cables Connect one end of the RCA (green, blue and red) cables to the Y/Pb/Pr IN connectors of the transmitter.
2 Install Install remote control batteries 1 2 Open the battery compartment. 3 Close the battery compartment. Insert two AAA batteries with correct polarity (+/-) as indicated. 3 Enjoy DC 5V Turn on the power of your HDTV 1 2 Go to the source menu under the settings menu of your HDTV. Select the HDMI input to which the receiver is connected. Note • You cannot control the receiver with the supplied remote control and the receiver follows the transmitter’s status to enter/exit the standby mode.
Switch on the transmitter Press on the remote control or transmitter in standby mode to turn it on. Select the source on the transmitter Press the source buttons: 1 HDMI , 2 HDMI, 3 INPUT, 4 INPUT on the remote control or transmitter until you see the available video from your device. Note • In standby mode, a red power LED displays on the transmitter . • Depending on equipment and the input selected, between input selection/start-up and being able to see the image on your TV can take up to 15 seconds.
Troubleshooting There is no video displayed on my TV screen. • Verify the POWER LED and SOURCE LED indicator on the transmitter: I cannot hear any sound or the sound is poor, what do I do? • • • • Ensure the TV volume control is adjusted correctly. Ensure the TV volume is not set to minimum or the sound is not muted. Ensure the audio cables of the transmitter are connected correctly. Ensure the Audio format is recognized/supported.