Headphones 1000 Series TAE1205 User manual Register your product and get support at www.philips.
Contents 1 Important safety instructions 2 Hearing Safety General information 2 2 2 Your Bluetooth in-ear headphones 3 What's in the box Other devices Overview of your Bluetooth wireless headphone 3 Get started Charge the battery Pair the headphones with your mobile phone 4 Use your headphones Connect the headphones to a Bluetooth device Manage your calls and music 3 3 4 5 5 5 6 6 6 5 Technical data 8 6 Notice 9 Declaration of conformity Disposal of your old product and battery Remove the i
1 Important safety instructions Hearing Safety Danger To avoid hearing damage, limit the time you use headphones at high volume and set the volume to a safe level. The louder the volume, the shorter the safe listening time is. Be sure to observe the following guidelines when using your headphone. • Listen at reasonable volumes for reasonable periods of time. • Be careful not to adjust the volume continuously upwards as your hearing adapts.
2 Your Bluetooth in-ear headphones Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. With this Philips in-ear headphones, you can: • enjoy convenient wireless handsfree calls; • enjoy and control wireless music; • switch between calls and music.
Overview of your Bluetooth wireless headphone Next / Volume up (Power On / Off / Pairing) LED indicator Charging slot Previous/Volume down
3 Get started Charge the battery Note Before you use your headphones for the first time, charge the battery for 2 hours for optimum battery capacity and lifetime. Use only the original USB charging cable to avoid any damage. Finish your call before charging the headphones, as connecting the headphones for charging will power the headphones off. Connect the supplied USB charging cable to the charging slot on the headphones and the charger/USB port of a computer.
4 Use your headphone Manage your calls and music On/off Connect the headphone to your Bluetooth device Turn on your mobile phone/ Bluetooth device. Task Power on Power off Press and hold the on/off button (>2s) to turn the headphones on. The headphones are reconnected to the last connected device automatically. If the last one is not available, the headphones try to reconnect to the second last connected device.
Summary of LED indicator Headphones status The headphones are connected to a mobile phone. Indicator The blue LED flashes for every 5 seconds. The headphones The blue LED are disconnected flashes for to a mobile phone every 10 seconds. The headphones The LED flashes are ready for blue and white pairing. alternatively. Low battery level. White LED double flashes Trigger once in 60 seconds. Charging The white LED turns on until battery is fully charged.
5 Technical data Music time: 7 hours Talk time: 5 hours Standby time: 60 hours Normal time for a full charge: 2 hours Battery: Rechargeable lithium polymer battery (100 mAh) Bluetooth version: 5.1 Compatible Bluetooth profiles: Bluetooth profile: HSP, HFP, A2DP,AVRCP Operating range: Up to 10 meters (33 feet) Speaker driver: 8 mm Transmitter power: < 10 dBm Frequency response: 20 – 20kHz Impedance: 32 ohm Sensitivity: 108.
6 Notice Declaration of conformity Remove the integrated battery Hereby, MMD Hong Kong Holding Limited declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on www.p4c.philips.com. If there is no collection/recycling system for electronic products in your country, you can protect the environment by removing and recycling the battery before disposing the headphones.
Notice of compliance The device complies with the FCC rules, Part 15. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC rules This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
7 Trademarks Bluetooth The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MMD Hong Kong Holding Limited is under license. Other trademarks and trade names are those of their respective owners. Siri Siri is a trademark of Apple Inc., registered in the U.S. and other countries.
8 Frequently asked questions My Bluetooth headphone does not turn on. The battery level is low. Charge the headphone. I cannot pair my Bluetooth headphones with my Bluetooth device. The Bluetooth is disabled. Enable the Bluetooth feature on your Bluetooth device and turn on the Bluetooth device before you turn on the headphone. The audio quality is poor and crackling noise can be heard. • The Bluetooth device is out of range.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. UM_TAE1205_00_EN_V1.
