User Manual

3 Get started
Charge your headphones
Note
Before you use your headphones for the first
time, charge the battery for 2 hours for
optimum battery capacity and lifetime.
Use only the original USB charging cable to
avoid any damage.
Finish your call before charging the
headphones, as connecting the headphones
for charging will power the headphones off.
Connect the supplied USB charging
cable to the charging slot on the
headphones and the charger/USB port
of a computer.
LED turns white during charging and
turns off when the headphones is fully
charged.
Tip
Normally, a full charge takes 2 hours.
Pair the headphones
with your mobile phone
Before you use the headphones with your
mobile phone for the first time, pair it with a
mobile phone. A successful pairing
establishes a unique encrypted link
between the headphones and mobile
phone.The headphones store the last 8
devices in the memory . If you try to pair
more than 8 devices , the earliest pained
device is replaced by the new one.
4 EN
Make sure that the headphones are
fully charged and turned off.
Press and hold the on/off button (>4s),
blue and whites LED flashes
alternately which means the
headphones enter Bluetooth pairing
mode. The headphones remain in
pairing mode for 5 minutes.
Make sure that the mobile phone is
turned on and its Bluetooth feature is
activated.
Pair the headphones with the mobile
phone. For detailed information, refer
to the user manual of your mobile
phone.
Enter the headset password "0000" (4
zeros) if prompted. For those mobile
phones featuring Bluetooth 3.0 or higher,
no need to enter a password.
Tip