Headphones 3000 Series TAH3209 User manual Register your product and get support at: www.philips.
Contents 1 Important safety instructions 2 2 Your wireless on-ear headphones 4 Hearing safety General information What's in the box Other devices Overview of your wireless headphones 2 2 4 4 5 3 Get started 6 4 Use your headphones 8 5 Reset the headphones 10 6 Technical data 10 7 Notice 11 Charge the battery 6 Pair for the �rst time 6 Pair with another Bluetooth device 7 Connect to your Bluetooth device Power on/off Manage your calls and music Voice Assistant Headphones LED indicator statu
1 Important safety instructions Hearing safety Danger To avoid hearing damage, limit the time you use headphones at high volume and set the volume to a safe level. The louder the volume, the shorter the safe listening time is. Be sure to observe the following guidelines when using your headphones. • Listen at reasonable volumes for reasonable periods of time. • Be careful not to adjust the volume continuously upwards as your hearing adapts.
To avoid risk of �re, the equipment is supplied only by external power source which output shall comply with PS1 (with output capacity less than 15W). Operating and storage temperatures and humidity • Store in a place where the temperature is between -20°C (-4°F) and 50°C (122 °F) with up to 90% relative humidity. • Operate in a place where the temperature is between 0°C (32°F) and 45°C (113 °F) with up to 90% relative humidity. • Battery life may be shorter in high or low temperature conditions.
2 Your wireless on-ear headphones Congratulations on your purchase, and welcome to Philips! To fully bene�t from the support that Philips offers, register your product at www.philips.com/support. With these Philips on-ear headphones, you can: • Enjoy convenient wireless handsfree calls • Enjoy and control music wirelessly • Switch between calls and music What's in the box Quick start guide Global Warranty Safety lea�et Other devices A mobile phone or device (e.g.
Overview of your wireless headphones 1 2 3 4 5 6 1 2 3 4 5 6 Volume + / Next track Volume - / Previous track Multi-Function Button (MFB) USB-C charging slot Power button LED indicator EN 5
3 Get started Charge the battery Note Before you use your headphones, place them in the charging box and charge the battery for 2 hours for optimum battery capacity and lifetime. Use only the original USB-C charging cable to avoid any damage. Finish your call before charging. Connecting the earpieces to charge will power them off. If the headset is not used for a long time, the rechargeable battery will begin to lose its charge.
The following example shows you how to pair the headphones with your Bluetooth device. 1 2 Turn on the Bluetooth function of your Bluetooth device, select Philips TAH3209. Enter the headphones' password “0000” (4 zeros) if prompted. For those devices featuring Bluetooth 3.0 or higher, there is no need to enter a password.
4 Use your headphones Connect the headphones to your Bluetooth device 1 2 Turn on the Bluetooth function of your Bluetooth device. Press and hold the the headphones on.
Three Way Calling Task Hold current call and accept an incoming call Hold current call and reject an incoming call Switch between second-way call and three-way call Button Operation MFB Single press MFB MFB Press and hold for 1 second Single press Button Operation Trigger Voice (Siri/Google) Assistant MFB Press and hold for 1 second Stop Voice Assistant MFB Single press 9 EN Headphones status Indicator The headphones are connected to a Bluetooth device The headphones are ready for pairin
5 Reset the headphones If you encounter any pairing or connection issue, you can follow the following procedure to reset your headphones to factory default settings. 1 On your Bluetooth device, go to the Bluetooth menu and remove Philips TAH3209 from the device list. 2 Turn off the Bluetooth function of your Bluetooth device. 3 Turn on your headphones. 4 Press and hold Vol + and V- for 4 seconds at the same time. 5 Follow steps in “Use your headphonesconnect the headphones to your Bluetooth device.
7 Notice Declaration of conformity Hereby, MMD Hong Kong Holding Limited declares that the product is in compliance with the essential requirements and other relevant provisions of RED Directive 2014/53/EU and UK Radio Equipment Regulations SI 2017 No 1206. You can �nd the Declaration of Conformity on www.philips.com/support.
Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) L’appareil ne doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
8 Frequently asked questions My Bluetooth headphones do not turn on. The battery level is low. Charge the headphones. I cannot pair my Bluetooth headphones with my Bluetooth device. The Bluetooth is disabled. Enable the Bluetooth feature on your Bluetooth device and turn on the Bluetooth device before you turn on the headphones. How to reset pairing.
Clean your headphones regularly. • Use a clean, damp cloth to clean your headphones - especially the sound conduits and the microphone holes regularly and avoid buildup of substances such as sweat or earwax. • If any sweat or water droplets are left in the sound conduits, air holes or microphone holes, the sound level will temporarily drop or cut out entirely. This is not a malfunction. Use a soft, damp cloth to dry the headphones thoroughly.
2024©MMD Hong Kong Holding Limited. All rights reserved. Speci�cations are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.