User manual

EN6
Perform initial setup
When the radio is powered on for the first
time, the [Setup wizard] appears on the display
panel. Follow the instructions below to configure
some basic settings.
To listen to Internet radio, you need to set up
Wi-Fi connection first Wi-Fi Protected Setup
(WPS) is a standard created by Wi-Fi Alliance
for easy establishment of secure wireless home
network If your wireless router supports WPS,
you can quickly and securely connect the radio
to the router through one of the two setup
methods: Push Button Configuration (PBC), or
Personal Identification Number (PIN). For those
that do not support WPS, you have another
option to connect the radio to the wireless
router.
Note
• Before you connect to a network, familiarize
yourself with the network router.
• Make sure that your home Wi-Fi network is
enabled.
• For better Wi-Fi reception, rotate and adjust the
position of the Wi-Fi antenna.
1
When [Setup wizard] is displayed, turn
SELECT knob to select [YES] to start the
setup. If you select [NO], you are asked to
run the wizard next time.
2
Press SELECT knob to confirm.
[12/24 hour format] is displayed.
3
Turn SELECT knob to select 12 or 24 hour
format.
4
Press SELECT knob to confirm.
Auto update list is displayed
5
Repeat steps 3 to 4 to select whether to
synchronize time with radio stations.
• [Update from DAB]: synchronize time
with DAB stations.
• [Update from FM]: synchronize time
with FM stations.
• [Update from Network]: synchronize
time with Internet radio stations.
If [Update from Network] is
selected, repeat steps 3 to 4 to set
time zone, and then repeat steps 3
to 4 to set daylight saving time.
• [No update]: deactivate time
synchronization.
If [No update] is selected, repeat
steps 3 to 4 to set date and time.
6
Repeat steps 3 to 4 to select [YES] to keep
network connected.
7
Repeat steps 3 to 4 to select the Wlan
region.
The radio begins to search for wireless
networks automatically.
A list of available Wi-Fi networks
appear.
8
Repeat steps 3 to 4 to select your Wi-Fi
network.
9
Press SELECT knob to select an option to
connect your wireless router
• [Push Button]: select this option if your
wireless router supports WPS and
PBC setup method. You are prompted
to press the connect button on your
router and then press OK to continue.
• [Pin]: select this option if your wireless
router supports WPS and PIN setup
method. The radio generates an 8-digit
code number that you can enter into
the router.