Wireless Speaker S5305 TAPR802 User manual Register your product and get support at www.philips.
Contents 1 Important Safety 2 Your wireless speaker Introduction What's in the box Overview of the speaker 3 Get started Charge the built-in battery Turn on/off 2 2 3 3 3 3 4 4 4 4 Play from Bluetooth devices 5 Play from Bluetooth devices Control playback Control phone call Pairing for stereo mode 5 5 5 5 5 Other features 6 Play from an external audio device 6 Multi-color LED light 6 6 Product information 7 7 Troubleshooting 8 General Bluetooth 8 Notice Compliance Care of the environmen
1 Important Safety Important safety instructions · Make sure that the power supply voltage corresponds to the voltage on the back or the underside of the unit. · The speaker shall not be exposed to dripping or splashing. · Do not place any source of danger on the · Make sure that there is enough free space around the speaker for ventilation. · Please use the speaker safely in an environment with temperature between 0° and 45°.
2 Your wireless speaker 1 • • • 2 Congratulations on your purchase, and support that Philips offers, register your product at www.philips.com/welcome. Enter Bluetooth pairing mode. Clear Bluetooth pairing information. Respond to an incoming call through Bluetooth connection. LED indicator 3 • In Bluetooth mode, press to pause or resume play. In Bluetooth mode, press twice to play the next track..
3 Get started Always follow the instructions in this chapter in sequence. Charge the built-in battery The speaker is powered by a built-in rechargeable battery. Note · Fully charge the built-in battery before using. · When the speaker is turned on and the battery is low, the battery level LED indicator blinks green. Caution · Risk of speaker damage! Make sure the power supply voltage corresponds to the voltage printed on the back or the underside of the speaker.
4 Play from Bluetooth devices Play from Bluetooth devices With this speaker, you can enjoy audio from your Bluetooth device. · Make sure that the Bluetooth function is enabled on your device. · The maximum distance for pairing the speaker and your Bluetooth device is 20 meters (66 feet). · Keep away from any other electronic device that may cause interference. 2 3 · To disconnect a device, press and hold for 2 seconds until the LED indicator blinks blue quickly.
1 Press to power on both speakers, they will enter Bluetooth pairing mode automatically. The speaker connected to your Bluetooth device will be used as the primary speaker. 5 Other features 2 On the primary speaker, press and hold to enter stereo pairing mode until the LED indicator blinks blue and green alternately. You will hear a prompt sound when successfully connected. The LED indicator lights up blue and green alternately on the primary speaker.
6 Product information Note · Product information is subject to change without prior notice. General information Power supply: 5V 3A Built-in Lithium battery 7.4V, 2600mAh Dimensions (W x H x D) 190 x 80 x 80 mm Weight (main unit) 0.61 kg Amplifier Output power 8W x 2 Frequency response 100 Hz - 20 kHz Signal to noise ratio > 70 dB Speakers Impedance 4 Maximum input power 8W Size 1.75" Bluetooth Bluetooth version 5.
7 Troubleshooting Warning · Never remove the casing of the speaker. To keep the warranty valid, never try to repair the speaker yourself. If you encounter problems when using this speaker, check the following points before requesting service. If the problem remains unsolved, go to the Philips website (www.philips. com/welcome). When you contact Philips, ensure that the speaker is nearby and the model number and serial number are available. General No power · Make sure the speaker is fully charged.
8 Notice Any changes or modifications made to this device that are not expressly approved by MMD Hong Kong Holding Limited may void the user’s authority to operate the product. never dispose of the product and batteries with normal household waste. Correct disposal of old products and batteries helps prevent negative consequences for the environment and human health. Removing the disposal batteries To remove the disposable batteries, see battery install section.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product. TAS5305_00_UM_V1.