Party Speaker 7000 Series TAX7207 User manual Register your product and get support at www.philips.
Contents 1 Important safety instructions Safety Care for your product Care of the environment Declaration of conformity Help and support Hearing safety Built-in battery care Trademarks 2 Your party speaker What’s in the box Party speaker 3 3 4 4 4 4 5 5 5 7 7 8 3 Get started 9 9 10 10 10 10 11 12 13 14 15 16 16 16 17 17 4 Product specifications 18 5 Troubleshooting 19 Connect to power Turn On and Off Volume control DBB control Charge the built-in battery Change light effect Play from Bluetooth devi
1 Important safety instructions Read and understand all instructions before you use your product. If damage is caused by failure to follow instructions, the warranty does not apply. • • • Safety • Know these safety symbols • CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
• • If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet. Parts of this product can be made of glass. Handle with care to avoid injury and damage. Risk of overheating! • Never install this product in a confined space. Always leave a space of at least four inches around the product for ventilation. Ensure curtains or other objects never cover the ventilation slots on the product.
Hearing safety • • • Listen at a moderate volume • Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss. • Sound can be deceiving. Over time your hearing ‘comfort level’ adapts to higher volumes of sound.
FCC information NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2 Your party speaker hon Headphon es Series CTN hones Headphon Series CTN hon Headphon es Series CTN Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your party speaker at www.philips.com/support.
Party speaker 8 9 10 11 12 14 15 16 17 18 13 This section includes an overview of the party speaker. 1 2 3 4 5 19 6 7 20 a (Light) touch key 9 10 11 12 13 Press to change speaker light mode. • Press and hold for 3 seconds to change speaker light brightness. 8 • b DBB touch key BASS effect setup. c 14+/－ 15 (Volume) 16 touch 17 key 18 19 Increase/Decrease the volume. d e • • (Play/Pause) touch key Start, pause or resume play. Press and hold to skip to next track.
i Voice changer button Press repeatedly to switch among different voice tones: Woman voice/ Man voice/Children voice/Normal effect. j PartyLink button Press to enter PartyLink pairing mode. k l TWS pair button • Press to enter True Wireless Stereo (TWS) pairing mode. • It work only when you have two identical speakers. • • Bluetooth / pair button Switch to Bluetooth mode. Press and hold to activate the pairing function in Bluetooth mode or disconnect the existing paired Bluetooth device.
Turn On and Off Press and hold touch key for 3 seconds to switch on/off the unit. Note •• The speaker will turn off automatically after •• 15 minutes without user operations and music playback. In case of no response of button or function error, you can press and hold Vocal fader and buttons for 10 seconds to force shutdown, then turn on the unit again to be used normally. Charge the built-in battery Plug the AC power cord to charge the built-in battery.
Check the battery level • • The speaker is designed with a smart battery check feature for your convenience. When the speaker is not in charging, press touch key to display the battery level on the LED indicators. Change light effect Turn speaker light on or off In power on mode, press (Light) touch key repeatedly to switch among different light modes of speaker light. Note •• When the battery level is low, all battery LED indicators will blink simultaneously and a prompt tone is heard.
Play from Bluetooth devices 5 To exit Bluetooth, you can: • • The product can stream music from your Bluetooth device to the system through Bluetooth. Note • •• A Bluetooth device which supports Bluetooth •• •• •• profile A2DP, AVRCP and with Bluetooth version as 5.0 + EDR. The maximum operational range between the party speaker and a Bluetooth device is approximately 30 meters. The player will also be disconnected when your device is moved beyond the operational range.
»» The first speaker entered TWS mode is master and LED3 on master speaker turns sold blue. »» The volume level, play/pause state, light mode in slave speaker will sync from master speaker after TWS connected. Pairing for stereo mode (TWS) Two speakers can pair with each other for stereo sound. Note •• TWS is worked only if there are two identical 3 To exit TWS, press and hold (TWS) button on either speaker. party speakers (Philips TAX7207).
Key & Operate Press and hold key Change brightness in all speakers on either speaker for 3 seconds Press and hold button on either speaker for 3 seconds »» Volume level, play/pause state, light mode in slave speakers will sync from master speaker after PartyLink connected. Action Exit TWS mode 5 Press and hold PartyLink button on master speaker. All speakers will exit PartyLink mode.
Key & Operate Action Press key on master speaker Play/pause the music on all connected speakers Press VOL +/－ key on master speaker Increase or decrease volume on all connected speakers Press DBB key on master speaker Change DBB setting on all speakers Press and hold power key on master speaker for 3 seconds Power off master speaker, all slave speakers will exit party link mode Press and hold key on selected slave speaker for 3 seconds Power off selected slave speaker, there is no effect on maste
Listen to an external device Sing through microphone With this product, you can listen to an external audio device such as an MP3 player. Adjust microphone volume Play from an MP3 player 1 Connect an audio input cable (not supplied) with a 3.5mm connector on both ends to: • The Audio in socket on the unit. • The headphone socket on the MP3 player. Connect a microphone (not supplied) into the Mic in socket of the unit, and adjust the microphone volume by turning the Mic vol knob.
Update firmware via USB 1 Check if there is the latest firmware version on www.philips.com/support. Search for your model and click on “Software and drivers”. 1 Software update files Pole-mounting your party speaker 1 Remove the cover from the bottom of the party speaker (please keep the cover). 2 Lift the party speaker to a speaker tripod (sold separately). 3 Adjust the speaker tripod to the appropriate height.
4 Product specifications Extension Codec MPEG 1 Layer 1 16 ~ 48 kHz 32 ~ 448 kbps MPEG 1 Layer 2 16 ~ 48 kHz 8 ~ 384 kbps MPEG 1 Layer 3 16 ~ 48 kHz 8 ~ 320 kbps MPEG 2 / MPEG 2.5 16 ~ 48 kHz Layer 1 8 ~ 256 kbps MPEG 2 / MPEG 2.5 16 ~ 48 kHz Layer 2 8 ~160 kbps MPEG 2/ MPEG 2.5 16 ~ 48 kHz Layer 3 8 ~ 160 kbps .wav WAV 16 ~ 48 kHz Up to 1536 kbps .wma WMA 8 ~ 48 kHz 5 ~ 320 kbps FLAC Up to 48 kHz / 16 bit Note •• Specifications and design are subject to change without notice. .
5 Troubleshooting Note Cannot display some files in USB device • •• Never remove the casing of the product. To keep the Warranty valid, never try to repair the system yourself. If you encounter problems when using this unit, check the following points before requesting service. If the problem remains unsolved, go to the Philips website (www.philips.com/support). When you contact Philips, ensure that your unit is nearby and the model number and serial number are available.
Specifications are subject to change without notice. Please visit www.Philips.com/support for the latest updates and documents. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited. or one of its affiliates, and MMD Hong Kong Holding Limited. is the warrantor in relation to this product. TAX7207RE_UM_EN_V1.
