Manual

Your Onis Memo recorder (Onis Mémo)16
Entering a remote control code
You need to enter a code in order to be able to use your memo recorder’s remote
control functions from another telephone e.g. to listen to your messages from a
telephone outside your home.
Press
R
, then press
-
until you reach
ANSW SETUP
. Press
o
.
Press
-
until you reach
RCC:
, then press
o
.
Enter your 4 digit code (e.g. 1234), then press
o
.
The handset beeps to confirm the code.
Press
R
to exit menu mode.
Note:
You can correct an error when you are entering your remote control code (RCC)
by using the
+
key.
If you wish to change your remote control code, repeat the above procedure.
If you to wish to erase the remote control code during step of the procedure
described above, press
+
four times, then press
o
, and finally press
R
.
Changing the number of rings
You can change the number of times your telephone rings before your memo
recorder answers a call.
Press
R
, then press
-
until you reach
ANSW SETUP
. Press
o
.
Press
-
until you reach RINGS, then press
o.
.
Press
-
or
+
to select 2 RINGS, 3 RINGS, 4 RINGS, 5 RINGS, or TOLL
SAVER, then press
o
to confirm your choice.
Press
R
to exit menu mode.
The Save function TOLL SAVER
This is used when you call into your memo recorder by remote control (see
“Calling
into your memo recorder by remote control”
on page 18).
When
TOLL SAVER
is selected, you can tell if a new message has been received
since you last rang in.
1
2
3
4
3
1
2
3
4