User Manual
Table Of Contents
- Guarantee
- MAIN ACCESS MENU
- Contents
- Base station
- Handset
- Security
- Installation
- Using the telephone
- Operating in "standby mode"
- Making a call from the handset
- Making a call from the Zenia Voice 6326 base station
- Dialling a number using the to direct dial keys
- Dialling an emergency number using the key
- Making a call from the Zenia Voice 6626 base station
- Answering a call from the handset
- Redial list
- Answering a call from the base station (6326 and Voice 6626)
- Adjusting handset or base station volume during a call
- Switching on loudspeakers from the handset
- Putting an incoming call on hold
- Recording a conversation from the Zenia Voice 6626 handset only
- Call log
- Private and shared phonebooks
- Voice dial (Zenia Voice 6626)
- Using the intercom
- Using the answer phone (Zenia Voice 6626 only)
- System configuration
- Maintenance and troubleshooting
- Index
- Remote control
System configuration
39
1.3 Headset volume
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Headset volume".
Select the desired volume level from the three options available.
1.4 Ringer type
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Ringer type".
Select the desired melody from the six options available.
1.5 Ringer volume
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Ringer volume".
Select the desired volume level from the six options available.
1.6 Switching key tones on/off
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Key tones" to switch this function on or off.
1.7 Earpiece tone
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Earpiece tone".
Select the desired tone setting from the three options available.
1.8 Loudspeaker tone
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Loudspeaker tone".
Select the desired tone setting from the three options available.
1.9 Headset tone
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "Headset tone".
Select the desired tone setting from the three options available.
1.0 CLI ringer (with caller identification)
When a call is received, you will hear the selected melody on your handset if the
number supplied by the network corresponds to a telephone number stored in the
private phonebook.
Go to the "SETTINGS" menu, then to the "Handset sounds" sub-menu and
select "CLI ringer".
Select the desired melody from the six options available.
prelim-zenia.book Page 39 Mardi, 20. juin 2000 10:31 10