User Manual
Table Of Contents
- Guarantee
- MAIN ACCESS MENU
- Contents
- Base station
- Handset
- Security
- Installation
- Using the telephone
- Operating in "standby mode"
- Making a call from the handset
- Making a call from the Zenia Voice 6326 base station
- Dialling a number using the to direct dial keys
- Dialling an emergency number using the key
- Making a call from the Zenia Voice 6626 base station
- Answering a call from the handset
- Redial list
- Answering a call from the base station (6326 and Voice 6626)
- Adjusting handset or base station volume during a call
- Switching on loudspeakers from the handset
- Putting an incoming call on hold
- Recording a conversation from the Zenia Voice 6626 handset only
- Call log
- Private and shared phonebooks
- Voice dial (Zenia Voice 6626)
- Using the intercom
- Using the answer phone (Zenia Voice 6626 only)
- System configuration
- Maintenance and troubleshooting
- Index
- Remote control
Maintenance and troubleshooting
53
Zenia 6626 base station (continued)
PROBLEM CAUSE SOLUTION
The answer phone
does not record
your personal
OGM.
Memory is full (an error
beep is heard).
Delete messages to free
sufficient memory.
An error beep is
heard from the
base station when
you try to access
the answerphone.
The answer phone is
already operating (play
or record).
Wait until the answer phone is
available and try again.
The answer phone
does not record
incoming calls.
The answer phone has
not been switched on.
Switch the answer phone on (see
“4.1 Selecting the answer
mode”, page 44) (Zenia 6626).
Message recording is not
switched on (answer and
record mode).
Switch answer and record mode
on (see “4.1 Selecting the
answer mode”, page 44) (Zenia
6626).
The answer phone
has stopped
automatically.
Answer phone memory
is full.
Delete messages to free
sufficient memory.
The red light is
flashing rapidly.
The answer phone's
maximum memory has
been reached.
Delete messages to free
sufficient memory.
A power failure has
occurred.
Reset date and time (see “3.3
Setting date and time”, page 42).
Remote control
does not work.
You did not enter the
correct code.
Retry (see “Checking messages
remotely”, page 35).
You did not set a remote
control code.
Change the code (see “4.8
Switching remote control on”,
page 46).
The answer phone's
maximum memory has
been reached.
Delete messages to free
sufficient memory.
prelim-zenia.book Page 53 Mardi, 20. juin 2000 10:31 10