User Manual
Table Of Contents
- Guarantee
- MAIN ACCESS MENU
- Contents
- Base station
- Handset
- Security
- Installation
- Using the telephone
- Operating in "standby mode"
- Making a call from the handset
- Making a call from the Zenia Voice 6326 base station
- Dialling a number using the to direct dial keys
- Dialling an emergency number using the key
- Making a call from the Zenia Voice 6626 base station
- Answering a call from the handset
- Redial list
- Answering a call from the base station (6326 and Voice 6626)
- Adjusting handset or base station volume during a call
- Switching on loudspeakers from the handset
- Putting an incoming call on hold
- Recording a conversation from the Zenia Voice 6626 handset only
- Call log
- Private and shared phonebooks
- Voice dial (Zenia Voice 6626)
- Using the intercom
- Using the answer phone (Zenia Voice 6626 only)
- System configuration
- Maintenance and troubleshooting
- Index
- Remote control
Maintenance and troubleshooting
55
Maintenance
Before cleaning the handset or the charging unit, unplug the power cable.
Notes:
Do not use detergents or other chemical cleaning agents. To clean the charging
contacts of the handset and the charging unit, use a dry, non-fluffy cloth.
PROBLEM CAUSE SOLUTION
An error beep is
heard during a
call.
Base station not ready. Retry when the other handset has
left the menu.
The handset you are
calling is already on a
call or out of range of
the base station.
Wait until the handset is available
and retry.
The handset batteries are
low (the call may be
interrupted).
Charge batteries (see “Charging
and discharging batteries”, page
10).
prelim-zenia.book Page 55 Mardi, 20. juin 2000 10:31 10