Monochrome CCD observation camera Contents Page Introduction.. -1 Conn acting the camera. The power The video cutout The connection sable Changing tha length of the cable BALTIC R—— installing the camera The mounting bracket Maintenance tips Technical specifications The Illustration referred to in this manual are printed on the insides of the two fold-out cover pages.
in a recasts on the back of the camera {fig. 4-2). You ean change its setting by sliding it with the help of a sharp pencil or toothpick. The connection cable ‘The connection cable supplied with the camera has a length of 10 meters (33 feet), I the distance between camera and monitor happens 1o be shorter or longer, you can easily make 2 special able, using a standard coaxial cable {available at your fester's) and the extra coaxial plugs supplied with your camera {fig, 7).
The mounting bracket » First determine where you want to install the camera, « Hold the camera In your hand at the spot where you want to install &, while checking on the monitor whether it does indeed cover the proper area from that position. « Fasten the mounting bracket to ceiling, wail or any other flat and solid surface. Use the screws and plastic mounting plugs when fastening the mounting bracket on a plastered surface, « Tighten the ball joint control knob (fig 55).
Technical specifications Image pluck-up device Scan ring system 3" CCD CIR, 625 lines, interlaced AF video and Audio VHF-l switchable between channels 3 and 4 {external switch) VCM8B120/007: CIR-B fixed focus {1 m to infinity} 74° horizontal, 58° vertical 410 25,000 kux {50 110 25,000 fux. {acceptable picture) 114" Whit worth 75 Ohm coaxial cable with cinch (RCA} and coaxial {Euro) pig 12V DO, supplied by the system monitor, via the coaxial cable 1.
