Observation Camera ENGLISH This device complies with pant 16 of the FOG rules. Operation is subject to the following two conditions: 1. this device may not cause hateful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. This devices is intended to be attached to a receiver that is not used to receive over-the-air broadest signals.
Table of contents A Page introduction Installation Sound Position Protective cover Video aut The lens Cable Tips for maintenance. Introduction Your new CCD camera is specially developed for use with a special observation system monitor. It features & sensitive microphone thus registering both images and sound via the monitor. Installation ‘Warning: A When a camera or access is connected or disconnected, the monitor should always be disconnected from the mains supply.
Sound if required, the microphone incorporated in the camera, can be switched off, {fig. A-13), #f an intercom box is included in the camera line, the sound of camera and intercom box wil be reproduced by the monitor.
The lens Caution: Do not ouch the glass of the fens. This could damage the dedicate coating on its surface. if the lens has to be cleaned, uses special fens cleaning tissues, available at any good camera stirs. Focus range: The camera supplied with a CS-mount fens does have a manual focus adjustment. This allows you fo find an optimal image sharpness for objects between 0.3 meter and infinity by rotating the front ring with the text FAR NEAR.
# 3 Horizontal Bkt of view 1t tetras (o surround) Distance sliest ta camera in metes Example: 28mm 4mm : 8mm 12mm the distance camera to object is 21 meters: simply multiply the value distance camera to object for 7 meters with 3. Next multiply the width of 1he scene, reproduced on the monitor screen by 3 also. The choice of a lens may affect the sensitivity of your camera. Consult the table below to see which type of lens is required for your particular application. Value Sensitivity of lens {ux} 1.
‘The given sensitivities are valid for a common fens transmission of 80% and a scene reflection of 76%. In case of an aura-irs lens the maximum Rumination level is far more than 100,000 lux {direct sunlight). The aperture of the lens will automatically close when used in a high-light environment. Automatic irks lenses: Note: When the camera is used outdoors for longer periods of ime (high-fight environments) the use of auto-irks fesses is recommended.
Caution: The CCD sensor in the camera is sensitive to dust. if you remove the ins from the camera you should always point the camera downwards to minimize possible deposit of dust. Never touch the sensor and/or use any cleaning materials. Only use clean, dry air to blow any particle form the surface of the sensor. ‘When using 2 manual-ifs ins, you should, in principle, set § tits largest aperture.
fight sources positioned withing the field of view of the camera. If nat possible you may also use some Neutral Density filters to reduce the illumination level of the camera. * The lens cable of an auto iis lens prevents the lens being rotated more than 380°. In case it should be necessary, disconnect the s cable, rotate the lens 360°, reconnect the is caber and continue the back-focus adjustment; Labile A 4-wire system cable (see specifications) is supplied standard.
