Video Recorders (VCR) Operating Manual

DWhile a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
STANDBY m button.
DIf the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’SWITCH TO STANDBY - TIMER
RECORDING’ will flash on the TV screen.
DIf you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
DIf you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’k’ will flash on the
video recorder display.
DIf you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
DIf `TIMER FULL´ appears on the TV screen when
you press the TIMER k button, you have used up all
the available TIMER blocks. If you want to clear or
check a programmed recording (TIMER block),
press the C button and select the TIMERR block
with the PROG. q or PROG. r button.
DProgramme numbers ’E1’ and ’E2’ are for
recordings from other sources (through scart socket
EXT.1 AV 1 or EXT.2 AV 2 ).
How to check or change a programmed
recording (TIMER)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMER k button on the remote control.
The programming mode selected last is marked.
c Select the line ’TIMER LIST’ with the B or A
button and confirm with the C button.
d Select the programmed recording (TIMER) you want to
check or change with the PROG. q or PROG. r button.
e Press the C button.
f Select the entry field with the D or C button.
g Change any information with the PROG. r or PROG. q
button or with the 0-9 buttons.
DUnder ’END’, use the SELECT button to select the
recording speed ’SP’ or ’LP’.
h Confirm with the OK button.
i To end, press the TIMER k button.
j Make sure that the cassette you have put in can be
recorded on. Switch off with the STANDBY m button.
DThe programmed recording will only function when
the video recorder is switched off with the
STANDBY m button.
How to clear a programmed recording
(TIMER)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMER k button on the remote control.
The programming mode selected last is marked.
c Select the line ’TIMER LIST’ with the B or A
button and confirm with the C button.
d Select the programmed recording (TIMER) you want to
clear with the B or A button.
e Press the CLEAR (CL) button.
f Confirm with the OK button.
g Switch off with the TIMER k button.
’NexTView Link’
This video recorder is equipped with the function ’NexTView
Link’. If your television is also equiped with this function, you
can mark TV programmes on the television for programming.
These TV programmes will automatically be transmitted to a
TIMER block on the video recorder. If you clear the marking of
the TV programme on the television, the corresponding TIMER
block on the video recorder will also be cleared.
For more information, read the instruction manual of your TV
set.
26