User's Manual

User Manual
© 2021 Phillips Connect Technologies LLC 4 / 10
2 Design
2.1 Basic Hardware
Items
Requirement
Baseband Chipset
Qualcomm Cat.M1
RF Transceiver
Qualcomm SDR
Memory
Internal
Air Interface
Support for LTE Cat.M1
Frequency
4G band support : Band2/4/5/12/13/25/26
BLE5.0 : 2.4GHz
Antenna
Internal Antenna / Chip Antenna
GPS Antenna
Dedicated high performance ceramic antenna
Interface
UART TX
UART RX
12V DC Input（1A current）
Relay Drive
GPIO
CAN(Option)
Voltage Monitor
Supported
Watchdog
Supported
Motion Detect
Supported
LED
2 LED Supported
Battery
Built in battery for backup（< 90mAH）
Power Cable connector type
8 pin
Power Consumption
< 5Watts
The Arrow-QG (Arrow-VI) provides support for specialized hardware features
through extended AT commands. The features supported include the following.
GPS
The major functionality of the GPS system is to compute the correlation results
between the incoming signal and the selected PRN code based on certain Carrier
Doppler Frequency, Code Doppler Frequency, code phase, carrier phase, and the
particular satellite the system is tracking or acquiring.
GPIO
The GPIO pins are presented to the external environment on the main connector. They
are general purpose bidirectional lines capable of providing system interrupts to
generate a report or drive logic levels to external devices. These lines are 2.8V logic
level and are 16V tolerant.
LED’s
Two LED status indicators are provided to verify correct installation and operation.