Instructions / Assembly

gripSTIK
®
Spray Adhesive
The information and recommendations contained herein are, to the best of Phillips Manufacturing Company’s knowledge and belief, accurate and reliable as of the date issued. Phillips Manufacturing Company has no
control over the conditions of handling and use, and makes no warranty regarding the results obtained from the use of this data. The information and recommendations are offered for the user’s consideration and
examination, and it is the user’s responsibility to determine that they are suitable and complete for its particular use. Phillips reserves the right to make alterations and amendments to the detailed specifications at its
discretion. Phillips disclaims responsibility for all actions, proceedings, liabilities, claims, damages, cost, losses, and expenses in relation to, or arising out of, incorrect utilization of this information.
Version 1.0 / Page 1 of 1
©2012 Phillips Manufacturing Company
Installation Recommendations
Phillips recommends installation in accordance with applicable ASTM standards and using prevalent industry standards.
General Installation Guidelines
Directions: Shake can. Spray two even coats of gripSTIK
®
Spray Adhesive on the corner bead,
holding 6-10 inches from bead. Install bead immediately and pressure on to the drywall. For ultimate
bond: Spray both the drywall and bead with an even coat and immediately install to the drywall. Bond
while tacky. With the handle of your taping knife apply pressure to the mud legs of the bead twice.
Staple the mud legs every 6-8 inches with 1/2" staples. Always test gripSTIK
®
Spray Adhesive in your
environment before use (especially in extreme heat, humidity or cold). For other substrates, a test in
typical operating environment for compatibility is recommended. For cold weather winter applications,
please refer to the installation recommendations in the Gypsum Association GA-220-06 of 50°F or
warmer.
Important to Avoid Clogging: After use, turn can upside down and spray a short jet of clear gas
until no glue comes out. Clean with a petroleum solvent if clogged.
Product Benefits
Phillips gripSTIK
®
Spray Adhesive is a high tack web based spray adhesive designed for adhering vinyl corner beads and
trims to drywall, especially Phillips gripSTIK
®
Drywall Beads and Trims. Phillips gripSTIK
®
Spray Adhesive features many
benefits:
 An adjustable nozzle for desired spray width and strength
 Works great adhering Phillips gripSTIK
®
vinyl beads and trims to drywall
 Available in standard industry size (17.0 oz.)
 Packaging is 12 cans per case
Applicable Standards
Phillips gripSTIK® Spray Adhesive meets California VOC content limits. VOC content is less than 55% by weight. See
MSDS for additional information.
Limitations
Product is designed for interior use.
Storage
Avoid damage and store in a covered area away from direct sunlight. Do not expose to heat or store at temperatures
above 120°F/49°C. Do not puncture or incinerate container, even when empty. Do not discard in compactor.
Made in the U.S.A.
Phillips is proud that all our beads, trims and accessories are made in the United States of America.