Pylontech Battery Guide

www.phocos.com 4 | P a g e
Any-Grid Master Battery Rack
For systems with multiple Any-Grids, this connection (marked green) can be made with any of the inverters,
but only a single unit. Remember, all Any-Grids in a synchronised system must be connected to a single
battery bank as shown here for a system with 4 Any-Grids in parallel:
If using two battery clusters / groups (only necessary if using 9 to 16 batteries), for all batteries except the C
models, the communication wiring is as follows:
 Master RS485 port from group 1 is connected via a standard straight Ethernet patch cable to a hub.
This hub can be purchased from Pylontech (the Pylontech LV-HUB is not required):
Alternatively, any RJ45 hub that simply connects in parallel all pin 1 ports, connects in parallel all pin
2 ports etc. up to pin 8 is sufficient, such as this for example https://www.amazon.com/-
/de/dp/B08BC4DGC5/ref=sr_1_14?dchild=1&keywords=ethernet+breakout+board&qid=16201312
92&sr=8-14 or this https://www.amazon.com/-
/de/dp/B07JH3LH2F/ref=sr_1_109?dchild=1&keywords=rj45+terminal+block&qid=1620132159&sr
=8-109:
PYLON