PSW-H Installation and User Manual
www.phocos.com    33  | P a g e    
41 
Maximum discharging current 
This setting is important to 
limit discharging current for 
some battery types. 
Disabled (Default) 
120 A 
Depending on the battery type used, its maximum discharge current 
may be lower than what the Any-Grid unit requires to deliver its full 
power to AC loads. If set to “Disabled” the unit will draw as much 
current from the battery as necessary to supply the loads. If 
overloaded by too much load power, settings menu 23 determines if 
the unit may switch to the AC input by-pass to deliver more power or 
protect itself by turning off permanently (until manual restart) or 
temporarily (depends on settings menu 06). 
If this setting is not “Disabled” then the unit will allow a maximum of 
the set discharge current. If this limit is surpassed for more than 5 
minutes, the unit will switch to the AC input by-pass temporarily to 
provide more power to the loads. If no AC source is available, then the 
unit will shut down for several seconds. After multiple failed attempts 
the unit will turn off without reattempting to start the loads again. 
Available values: Disabled and 30 ~ 120 Adc in 10 Adc increments for 
48 Vdc model. 
Available values: Disabled and 30 ~ 150 Adc in 10 Adc increments for 
24 Vdc model. 
93 
Erase all datalogger contents 
No reset (Default) 
Reset 
94 
Datalogger storage period 
10 days (Default) 
The Any-Grid unit can store 
measurement data with the 
following frequency: 
3 days: 20 entries per hour 
5 days: 12 entries per hour 
10 days: 6 entries per hour 
20 days: 3 entries per hour 
30 days: 2 entries per hour 
60 days: 1 entry per hour 
Once the memory is full, the oldest 
entries are over-written. 
Available values: 3, 5, 10, 20, 30 and 
60 days. 
Irrespective of this setting the unit 
stores the last 100 error / warning 
event codes. 
95 
Time setting: minute 
Allows setting the current time in 
minutes. 
Available values: 00 ~ 59 minutes. 
96 
Time setting: hour 
Allows setting the current time in 
hours (24h notation). 
Available values: 00 ~ 23 hours. 










