Phocos Any-Grid™ series Any-Grid™ use with Lithium battery models: Arco Invincible III Applicable for Any-Grid™ PSW-H-5kW-230/48V, PSW-H-5kW-120/48V and PSW-H-6.
1.0 Introduction This guide outlines the recommended settings and establishing communication for operation of one or more AnyGrid™ PSW-H-5kW-230/48V, PSW-H-5kW-120/48V or PSW-H-6.5kW-120/48V hybrid inverter chargers with Arco Invincible III battery modules in the low-voltage (50.4 Vdc nominal) configuration, referred to in this guide as “battery modules”. Note that the charge/discharge settings are automatically negotiated with the battery if this guide is used and cannot be changed.
System Overview 3.0 Arco batteries 4.0 Battery Sizing To maintain the full battery warranty, each battery module should be sized not to exceed 40 Adc continuous current (verify Arco manual for details). It is thus recommended to use at least 3 battery modules in parallel to deliver both sufficient continuous current and peak current for a single PSW-H-5KW at full power. When using multiple Any-Grid units, be sure to increase the number of batteries accordingly to sustain the required currents.
Any-Grid Master Battery 5. Ensure the battery modules are wired as outlined in the Arco battery manual. Turn on the batteries: 6. Ensure the “ON/OFF” load power button of the Any-Grid(s) is in the ON position (depressed), but no loads are connected: The Any-Grid(s) should now be running, the display(s) on. 7. Apply the following setting on the Any-Grid to which the Arco battery bank is connected with the communication cable.
The content of this document is subject to change without notice. Copyright © 2022 Phocos AG, all rights reserved. Version: 20220211 Phocos AG Magirus-Deutz-Str. 12 89077 Ulm, Germany Phone +49 731 9380688-0 Fax +49 731 9380688-50 www.phocos.com info@phocos.com www.phocos.
