User manual

common rectifier type diode (1A, 200V rating), in parallel with the relay coil (see below).
3. Operation
3-1. Turning on inverter
 Change the DIP switch setting to the mode you wish first, then turn the inverter on. The
buzzer beeps twice, LED shows green -> orange -> red -> green sequence. The inverter
is now ready to deliver AC power to your loads.
 If there are several loads in use, turn them on separately after the inverter has been
turned “ON” in order to prevent the OVP caused by the power surge.
3-2. Turning off inverter
Set the main switch to the OFF position, the inverter output turns off and the LED goes off.
3-3. Remote controller operation
 Make sure the main switch is in the “off” position.
 Connect the remote controller to the inverter.
 Turn the main switch to remote control position.
 Turn the remote switch “on” or “off” to control the inverter operation or not.
23
ENG
Wiring diagram for a PV system using charge controllers