Instructions

Table Of Contents

PSI-MODEMSHDSL/SERIAL

2-2

PHOENIX CONTACT 104275_en_c00

2.1 Mounting the module on a DIN rail

2.1.1 Mounting on a DIN rail (single device)

Figure 2-1 Mounting and removal (single device)

Mounting:

• Place the device onto a grounded 35 mm DIN rail from above so that the upper housing

keyway hooks onto the top edge of the DIN rail (see Figure 2-1 A).

• Holding the device by the housing cover, carefully push the device towards the mount-

ing surface.

• Once the snap-on foot has been snapped onto the DIN rail, check that it is fixed secure-

ly.

Removal:

• Use a suitable screwdriver to release the locking mechanism on the snap-on foot of the

device (see Figure 2-1 B).

• Hold onto the device by the housing cover and carefully tilt it upwards.

• Carefully lift the device off the DIN rail.

WARNING:

Only mount and remove the modem when the power supply is disconnected.

NOTE:

The DIN rail must be connected to PE to ensure safe operation.

101973A008