Instructions
Table Of Contents
- Please observe the following notes
- Table of contents
- 1 Description of the SHDSL permanent line modem
- 2 Hardware installation
- 3 Configuration via PSI-CONF
- 4 Optimization
- 5 Eliminating errors
PSI-MODEMSHDSL/SERIAL
2-12
PHOENIX CONTACT 104275_en_c00
2.3.5 Connecting the USB interface
You can configure the modem or read diagnostic information via the USB interface.
Power can also be supplied via USB for configuration purposes. The "VCC" LED flashes at
1 Hz in this case. SHDSL operation is not possible.
To connect the modem to a computer, use the CABLE-USB/MINI-USB-3,0M cable (Order
No. 2986135).
• Connect the mini-USB plug (type B) to the modem and the USB plug to your computer.
The USB interface is used to configure the modem via the PSI-CONF configuration soft-
ware.
The USB interface cannot be used for data transmission.
DSL operation is not possible when power is supplied via USB.