Instructions
Table Of Contents
- 1 Description
- 2 Table of contents
- 3 Ordering data
- 4 Technical data
- Dimensions (nominal sizes in mm)
- General data
- Connection data
- Interface PROFINET
- PROFINET
- Supply: Module electronics, sensors and actuators (US)
- Supply: Actuators (UA) for additional devices
- Digital inputs
- Digital outputs
- Electrical isolation/isolation of the voltage areas
- Test section
- Mechanical tests
- Conformance with EMC Directive 2014/30/EU
- Approvals
- 5 Internal circuit diagram
- 6 Pin assignment
- 7 Connection example
- 8 Connection notes
- 9 Factory reset via rotary encoding switches
- 10 Local status and diagnostic indicators
- 11 PROFINET IO Device
- 12 Startup
- 13 WBM - Web-based management
- 14 SNMP - Simple Network Management Protocol
- 15 Device description file (GSDML)
AXL E PN DIO16 M12 6M
8443_en_11 PHOENIX CONTACT 11 / 21
7 Connection example
Figure 7 Example of connection of sensors and
actuators
8 Connection notes
IN/OUT 6
+24 V
IN/OUT 5
IN/OUT 12
+24 V
IN/OUT 11
NOTE: Data corruption or loss
Implement the FE connection using mounting
screws, in order to ensure immunity to
interference.
NOTE: Device damage
To ensure IP65/67 degree of protection, cover
unused sockets with protective caps.
NOTE: Damage to the electronics
Only supply the sensors with the voltage U
S
provided at the terminal points.
NOTE: Damage to the electronics
Observe the correct polarity of the supply
voltages U
S
and U
A
in order to prevent
damage to the device.
NOTE: Malfunction
When connecting the sensors and actuators,
observe the assignment of the connections to
the PROFINET input and output data.
Secure the device to a level surface or to a
profile. Do not use this device to bridge gaps,
in order to prevent forces being transmitted
via the device.
Use standard M5 screws with toothed lock
washer and self-locking nuts. Observe the
maximum torque of the screws.