Instructions
Table Of Contents
- 1 Description
- 2 Table of contents
- 3 Ordering data
- 4 Technical data
- Dimensions (nominal sizes in mm)
- General data
- Connection data
- Interface PROFINET
- PROFINET
- Supply: Module electronics, sensors and actuators (US)
- Supply: Actuators (UA) for additional devices
- Digital inputs
- Digital outputs
- Electrical isolation/isolation of the voltage areas
- Test section
- Mechanical tests
- Conformance with EMC Directive 2014/30/EU
- Approvals
- 5 Internal circuit diagram
- 6 Pin assignment
- 7 Connection example
- 8 Connection notes
- 9 Factory reset via rotary encoding switches
- 10 Local status and diagnostic indicators
- 11 PROFINET IO Device
- 12 Startup
- 13 WBM - Web-based management
- 14 SNMP - Simple Network Management Protocol
- 15 Device description file (GSDML)
AXL E PN DIO16 M12 6M
8443_en_11 PHOENIX CONTACT 12 / 21
9 Factory reset via rotary encoding switches
You can do a factory reset using the rotary encoding
switches.
After modifying the switch position, restart the device, as the
modification to the switch position does not take effect
during operation.
Figure 8 Rotary encoding switches
The image shows code 0F.
Switch position 0F
All settings are reset to default settings, including
IP parameters.
S1 S2 Code Function
0 F 0F Resetting to the
default settings
The device is ready for operation after
powering up, as soon as the RDY LED lights
up green.
A connection to the device however cannot be
established in this switch position.
As soon as the RDY LED lights up green, a
new switch position can be selected on the
rotary encoding switch and the device can be
restarted.
0
2
4
6
8
9
A
B
C
D
E
F
S2
x1
0
2
4
6
8
10
12
14
S1
x10