Datasheet

© PHOENIX CONTACT - 06/2006
Data Sheet
INTERFACE
100241_07_en 1
PHOENIX CONTACT GmbH & Co. KG • 32823 Blomberg • Germany
Phone: +49 - 52 35 - 30 0 • Fax: +49 - 52 35 - 34 12 00 • www.phoenixcontact.com
www.phoenixcontact.com/salesnetwork
MCR-S-…-DCI
1 Description
MCR-S-…-DCI current transducers offer users the option
of ordering a preconfigured device, configuring the device
themselves via DIP switches or programming it with
MCR/PI-CONF-WIN configuration software
(Order No. 2814799).
The MCR-S-1-5-UI-DCI module provides not only the
standard 1 A and 5 A input signals, but also the option of
setting current ranges of 0 ... 0.2 A to 0 ... 11 A progressively.
With a measuring range of 0 ... 9.5 A to 0 ... 55 A, the
MCR-S-10-50-UI-DCI is ideal for measuring higher motor
currents.
DC, AC, and distorted currents can be equally well
measured.
In addition to an analog output, these current transducers
also have an optional relay and transistor output, e.g., for
alarm monitoring.
When ordering, the desired configuration to which the
device is to be adapted must be specified (see order key on
page 5 and page 8).
Features
– Progressive adjustment of measuring range
– True r.m.s. value measurement
– 3-way electrical isolation according to EN 61010
– With optional relay and transistor output
– 22.5 mm ME housing
POWER
U,I
IN OUT
I
FL
Power
Current Transducer up to 55 A,
Programmable and Configurable
Observe the safety instructions on page 10.
Make sure you always use the latest documentation.
It can be downloaded at www.download.phoenixcontact.com.
A conversion table is available on the Internet at
www.download.phoenixcontact.com/general/7000_en_00.pdf
.
This data sheet is valid for all products listed on the following page: