Datasheet

1Description
FO converter with B-FOC (ST
®
) connection
(1300nm), for converting 10/100Base-T(X) to
multi-mode fiberglass (50/125µm)
FL MC EF 1300 MM ST
© PHOENIX CONTACT
Data sheet
The FLMCEF1300MMST FO converter provides a high
level of immunity to interference and a long transmission
range in industrial applications by converting the
10/100Base-T(X) Ethernet interface to fiber optics
(100Mbps according to FX standard).
If longer distances are to be covered or if an existing fiber-
glass installation is used, the FO converter covers distances
of up to 10,000m with 62.5/125µm or 6400m with
50/125µm multi-mode fiberglass in full duplex mode.
Features
– 10/100Base-T(X) auto negotiation
– Auto MDI/MDIx switchover
–Operating mode and speed can be set manually
– Link fault pass through (LFP)
– Far End Fault signaling (FEF)
–B-FOC (ST
R
) connection
– Mounting on a 35 mm DIN rail
– Redundant power supply possible
WARNING: Explosion hazard when used in potentially explosive areas
The module is a category 3 item of electrical equipment. Follow the instructions provided here during installa-
tion and observe the safety instructions.
Make sure you always use the latest documentation.
It can be downloaded from the product at phoenixcontact.net/products
.
This data sheet is valid for all products listed on the following page:
104914_en_02
2013-12-16