User Manual

Basic device configuration
108904_en_00 PHOENIX CONTACT 37 / 192
5.1.10 Step 9: Activating the PIN
Figure 5-12 Activating the PIN
1. To activate the PIN, press the button.
2. Use the buttons and to enter the desired PIN.
3. To apply the changes, press the button.
4. To finish the basic device configuration, press the button.
For additional information, please refer to Section “Configuration” on page 69.
5.2 Basic device configuration via the web server
By default, a static IP address is set for the device. To start the basic device configuration
via the web server, open the Internet browser. Enter the following URL:
Make sure that your computer and the energy measuring device are in the same network.
To ensure safe operation, we recommend changing the access data for the display!
We recommend using the integrated web server to perform the device configuration. You
can access the web server directly after you have switched on the device. An installation
wizard guides you through the basic device configuration process.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
DHCP: Off
DNS server: 0.0.0.0