User Manual

Basic device configuration
109357_en_00 PHOENIX CONTACT 35 / 196
5.1.6 Step 5b: Current input (energy measuring device with
Rogowski coil)
Figure 5-8 Current input (energy measuring device with Rogowski coil)
1. Use the button to open the edit mode of the “Manufacturer” device setting.
2. To make changes, use the buttons and .
3. To apply the change, press the button.
The same procedure applies to editing the nominal current.
4. To activate or deactivate a checkbox, press the button.
5. To continue the basic device configuration, press the button.
5.1.7 Step 6: Voltage input
Figure 5-9 Voltage input
1. If you use a voltage transducer, activate the checkbox with the button. When you
activate the checkbox, the primary and secondary voltage is displayed.
2. If no voltage transducer is used, enter the nominal voltage by means of the and
buttons.
3. Select it with the button.
4. Use the buttons and to make changes.
5. To save the changes, press the button.
6. To proceed, press the button.