User Manual

Mounting and installation

108904_en_00 PHOENIX CONTACT 17 / 192

3 Mounting and installation

3.1 Mounting

You can install the device in a front panel or control cabinet door.

Figure 3-1 Mounting

Figure 3-2 Mounting terminal covers

To ensure a firm and tight fit of the device in accordance with IEC 60529/EN 60529, proceed

as follows during mounting:

1. Stretch the seal over the rear of the device and position it against the inside of the dis-

play.

2. Push the device into the mounting opening from the front. Ensure that the seal is posi-

tioned correctly.

3. Secure the device from the rear using the four retaining elements until the device snaps

firmly into place.

4. Safeguard the voltage and current measurement inputs against unauthorized access

by installing terminal covers.

5