User Manual

Device settings and information
108904_en_00 PHOENIX CONTACT 65 / 192
7.3.7 Adjusting the display via the web server
Navigation on the web
server
“Settings, Display”
Figure 7-21 Web server: “Settings, Display”
Status Here, the current settings for the display are shown. It is also possible to modify them here.
Standard display Here, you can choose between the formats “IEC” or “IEEE”.
Activate configuration via
display
If this checkbox has been enabled, you can configure the device via the display.
Illumination duration Here, you can select between:
– Steady off
– Set duration (in hh:mm:ss)
– Steady on
Red color change in case
of error
If this checkbox is enabled, the color change in the event of an error is active. If this check-
box is disabled, the color change in the event of an error is inactive.
In the default setting, this checkbox is enabled.