Datasheet

https://www.phoenixcontact.com/us/produkte/2967293
Nov 9, 20132/11
Relay Module-PLC-RSC- 60DC/21-21-2967293
Technical data
Coil side
Typical release time
10 ms
Operating voltage display
Yes
Protective circuit
Protection against polarity reversal Polarity protection diode
Protective circuit
Free-wheeling diode Damping diode
Contact side
Contact type
2 PDT
Contact material
AgNi
Maximum switching voltage
250 V AC/DC (The separating plate PLC-ATP should be installed
for voltages larger than 250 V (L1, L2, L3) between identical
terminal blocks in adjacent modules. Potential bridging is then
carried out with FBST 8-PLC... or ...FBST 500...)
Minimum switching voltage
5 V AC/DC (at 10 mA)
Maximum inrush current
15 A (300 ms)
Min. switching current
10 mA (At 5 V)
Limiting continuous current
6 A
Interrupting rating (ohmic load) max.
140 W (at 24 V DC)
Interrupting rating (ohmic load) max.
85 W (at 48 V DC)
Interrupting rating (ohmic load) max.
60 W (at 60 V DC)
Interrupting rating (ohmic load) max.
44 W (at 110 V DC)
Interrupting rating (ohmic load) max.
60 W (at 220 V DC)
Interrupting rating (ohmic load) max.
1500 VA (for 250 V AC)
General
Test voltage relay winding/relay contact
4 kV AC (50 Hz, 1 min.)
Test voltage PDT/PDT
2.5 kV AC (50 Hz, 1 min.)
Operating mode
100% operating factor
Mechanical service life
3 x 10
7
cycles
Inflammability class according to UL 94
V0
Name
Standards/regulations
Standards/regulations
IEC 60664
Standards/regulations
EN 50178
Standards/regulations
IEC 62103
Rated surge voltage / insulation
6 kV (safe isolation: control side / contact side)
Pollution degree
2
Surge voltage category
III
Mounting position
Any
Assembly instructions
In rows with zero spacing
Connection data
Connection method
Screw connection
Conductor cross section solid min.
0.14 mm²
Conductor cross section solid max.
2.5 mm²
Conductor cross section stranded min.
0.14 mm²