Datasheet

For further information and full technical data, visit phoenixcontact.net/products
211PHOENIX CONTACT
Terminal blocks - CLIPLINE complete
QT... fast connection terminal blocks
The reducing bridge enables time-saving
and low-cost potential distribution when
supplying large cross sections. The reducing
bridge connects, e.g., an ST10 terminal
block to a QTC1,5 or QTC2,5.
The double function shaft can be used to
connect any number of terminal blocks with
two-position bridges. The 2- to 50-pos.
bridges allow up to 50 terminal blocks to be
bridged in one step.
A jumping bridge is created by removing
individual forks from the standard bridge.
Two potentials can then be routed in
parallel. There is scope for marking on the
top of the bridge.
The P-FIX isolated feed-through
connector, P-DI isolating plug, P-CO
component connector, and P-FU cartridge
fuse plug with a 5.2 mm pitch can be used in
the universal plug-in zone of the disconnect
terminal block.
A test plug with a 2.3mm diameter is
available for measuring lines. All
measurement and test work can be
completed at speed using test adapters for
4mm diameter test plugs and the modular
test plugs.
The hybrid versions combine the time-
saving rapid connection method with the
benefits of the screw or spring-cage
method.
Lever-type fuse terminal blocks are also
available to suit the function terminal
blocks. The retentive fuse holders can be
used in a black housing with a micro fuse or
in an orange housing with a contact metal.
Cover segments are used to cover
protruding terminal block segments of
three- or four-conductor terminal blocks,
when adding two-conductor terminal
blocks. Fingers are thereby protected from
contact.
QT COMBI basic terminal blocks and
plugs with fast connection are available for
the plug-in configuration of signal wiring
with fast connection. See “COMBI” section,
page 225.