User Manual
Table Of Contents
- 1 Description
- 2 Table of contents
- 3 Ordering data
- 4 Technical data
- Dimensions
- General data
- Power supply for module electronics
- Wireless interface
- Digital inputs
- Digital outputs
- Analog inputs
- Analog outputs
- Test voltage
- Ambient conditions
- Certification
- Emitted interference in acc. with EN 61000-6-4
- Conformance
- Limitation of simultaneity, derating
- Tolerance of analog inputs and outputs
- 5 Safety regulations and installation notes
- 6 Local diagnostic and status indicators
- 7 Connect supply, actuators, and sensors
- 8 Basic circuit diagram
- 9 Connection example
- 10 Assignment of terminal points to the remote station
- 11 Antennas
ILB BT ADIO MUX...
Preliminary Preliminary Preliminary Preliminary
7173_en_11 PHOENIX CONTACT 10 / 18
5.3 FCC approval
This device complies with Part 15 of the FCC rules and
Industry Canada's licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not explicitly approved by
PhoenixContact could cause the device to cease to comply
with FCC rules Part15, and thus void the user's authority to
operate the equipment.
Radio frequency exposure:
The device contains a radio transmitter and receiver. During
communication the device receives and transmits radio
frequency (RF) electromagnetic fields (microwaves) in the
frequency range of 2400MHz to 2483.5MHz.
RF Exposure Statement:
This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and your
body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
5.4 Approval for Japan
NOTE: Interference
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference, in which case, the
user will be required to correct the
interference at his own expense.
Japanese Radio Law and Japanese Telecommunications Business Law Compliance
The device is granted pursuant to the Japanese Radio Law ( ).
This device should not be modified (otherwise the granted designation number will
become invalid).
Contains:
XXX-XXXXXX