User Manual
Table Of Contents
- 1 Description
- 2 Table of contents
- 3 Ordering data
- 4 Technical data
- Dimensions
- General data
- Power supply for module electronics
- Wireless interface
- Digital inputs
- Digital outputs
- Analog inputs
- Analog outputs
- Test voltage
- Ambient conditions
- Certification
- Emitted interference in acc. with EN 61000-6-4
- Conformance
- Limitation of simultaneity, derating
- Tolerance of analog inputs and outputs
- 5 Safety regulations and installation notes
- 6 Local diagnostic and status indicators
- 7 Connect supply, actuators, and sensors
- 8 Basic circuit diagram
- 9 Connection example
- 10 Assignment of terminal points to the remote station
- 11 Antennas
ILB BT ADIO MUX...
Preliminary Preliminary Preliminary Preliminary
7173_en_11 PHOENIX CONTACT 9 / 18
5 Safety regulations and installation notes
5.1 Intended use
The devices are intended for application in industrial
environments.
The wireless system is ClassA equipment and may cause
radio interference in residential areas. In this case, the
operator may be required to implement appropriate
measures and to pay the costs incurred as a result.
This device complies with R&TTE device class 1, with the
following restrictions on use according to ERC
recommendation 70-03:
Please note that, in combination with antennas, the
maximum permissible transmission power may be
exceeded. In this case, set the transmission power via the
software.
5.2 Installation notes
• Installation, operation, and maintenance may only be
carried out by qualified electricians. Follow the
installation instructions as described.
• When installing and operating the device, the
applicable regulations and safety directives (including
national safety directives), as well as general technical
regulations, must be observed. The technical data is
provided in the package slip and on the certificates
(conformity assessment, additional approvals where
applicable).
• The device must not be opened or modified. Do not
repair the device yourself, replace it with an equivalent
device. Repairs may only be carried out by the
manufacturer. The manufacturer is not liable for
damage resulting from violation.
• The IP20 protection (IEC 60529/EN 60529) of the
device is intended for use in a clean and dry
environment. The device must not be subject to
mechanical strain and/or thermal loads, which exceed
the limits described.
• The device complies with the EMC regulations for
industrial areas (EMC classA). When using the device
in residential areas, it may cause radio interference.
• The device is only intended for operation in the control
cabinet and with SELV according to IEC 60950/
EN 60950/VDE 0805. The device may only be
connected to devices, which meet the requirements of
EN 60950.
• Operation of the wireless system is only permitted when
using accessories available from Phoenix Contact. The
use of any other components can lead to the withdrawal
of the operating license.
Norway: The device must not be operated within
20km of Ny Ålesund town center.
Turkey: The device must only be operated with
PhoenixContact antennas - according to the
regulations in Gazette "Short Range Radio
Devices (SRD) Regulations" no. 26464 dated
16/03/2007.
Install the wireless module at least 1m away
from other devices using the 2.4GHz
frequency band (e.g., WLAN, Bluetooth,
microwave ovens). Otherwise, both the
transmission quality and data transmission
rate will be reduced.
WARNING:
Observe the following safety notes when
using the device.