Datasheet

RPI-BC 107,6 DEV-KIT KMGY
107161_en_00 PHOENIX CONTACT 12 / 13
• Fit the PCB holders provided onto the Raspberry Pi.
Make sure that the arrow on the PCB holder is pointing
in the direction of the SD card slot.
• Insert the plastic catches in the holes provided on the
Raspberry Pi.
• Push the Raspberry Pi into the housing with a slight
rotary motion.
Insert the Raspberry Pi so that its interfaces fit in the
corresponding openings in the housing. Push down the
Raspberry Pi until the PCB holders snap into the
housing.
• Connect the required interfaces on the Raspberry Pi.
The interfaces on the long side will be difficult to access
later (e.g., micro USB for power supply, HDMI port, CSI
interface for a camera or composite video output).
• Lead the adapter out of the housing.