User Manual

Data Sheet / User Manual RB-TW-2400
DataUserManual FCC_05.doc PHOENIX CONTACT
23/3
0
The parameter address high and low bytes are used to address the parameter which should be read or
written to. A table with parameter addresses is shown in the next subsection.
The data field is used optionally. It can be utilized for parameter values which have a length of only
one byte. In order to use this field for parameter data the length value has to be set to ‘0’. In read-
requests and write-responses it is ignored.
Configuration Parameters
The following table lists the user-accessible parameters, their addresses, their lengths and if applicable,
their meaning.
Parameter Adr
Hi
Adr
Lo
Length Meaning
Node ID 0 1 1 1 = master, 2-250 = slave or repeater
Repeat 0 2 1 0 = do not repeat, 1 = repeat (ignored at master)
OTA Datarate 0 3 1 2 = 16k, 3 = 125k, 4 = 250k, 5 = 500k
NetType 2 13 1 0 = Mesh, 1 = Star/P2P
Network ID 2 15 2 0…127, >127 reserved
Retries 2 5 1 2 = 1 Retry
TX Power 1 4 1 0…20dBm
LNA Enabled 1 5 1 0 = off, 1 = on
RF-Band 1 6 1 1…8