User Manual

Data Sheet / User Manual RB-TW-2400
DataUserManual FCC_05.doc PHOENIX CONTACT
26/3
0
6 FCC and IC Compliance for RB-TW-2400
6.1 FCC Statement for RB-TW-2400
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
6.2 Antenna
Our module type RB-TW-2400 is for OEM integrations only. The end-user product will be
professionally installed in such a manner that only the authorized antennas are used.
6.3 Caution
Any changes or modifications NOT explicitly APPROVED by Phoenix Contact could cause the
module to cease to comply with FCC rules part 15, and thus void the user's authority to operate the
equipment.
6.4 IC Compliance
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This device has been designed to operate with an antenna having a maximum gain of 9 dBi.
Having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.