User Manual

Data Sheet / User Manual RB-TW-2400

DataUserManual FCC_05.doc PHOENIX CONTACT

27/3

The installer of this radio equipment must ensure that the antenna is located or pointed such that it

does not emit RF field in excess of Health Canada limits for the general population; consult Safety

Code 6, obtainable from Health Canada's website

www.hc-sc.gc.ca/rpb

User manuals for transmitters equipped with detachable antennas shall also contain the following

notice in a conspicuous location:

This radio transmitter (identify the device by certification number, or model number if Category II)

has been approved by Industry Canada to operate with the antenna types listed below with the

maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna

types not included in this list, having a gain greater than the maximum gain indicated for that type, are

strictly prohibited for use with this device.

Immediately following the above notice, the manufacturer shall provide a list of all antenna types

approved for use with the transmitter, indicating the maximum permissible antenna gain (in dBi) and

required impedance for each.

6.5 Labeling Requirements for End Product

For an end product using the product RB-TW-2400 there must be a label containing, at least, the

following information:

Contains FCC ID: YG3RAD2400A

Contains IC: 4720B-RAD2400A

The label must be affixed on an exterior surface of the end product such that it will be visible upon

inspection in compliance with the modular approval guidelines developed by the FCC.

In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a

conspicuous location on the device:

"This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions;

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

operation."

When the device is so small or for such use that it is not practicable to place the statement above on it,

the information shall be placed in a prominent location in the instruction manual or pamphlet supplied