User Manual

Data Sheet / User Manual RB-TW-2400

DataUserManual FCC_05.doc PHOENIX CONTACT

28/3

to the user or, alternatively, shall be placed on the container in which the device is marketed. However,

the FCC ID label must be displayed on the device.

In case, where the final product will be installed in locations where the end-user is not able to see the

FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end-product

manual.

6.6 RF-exposure Statement

This equipment should be installed and operated with minimum distance 20cm between the radiator &

your body. This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter. As long as these conditions above are met, further transmitter test will not be required.

However, the OEM integrator is still responsible for testing their end-product for any additional

compliance requirements required with this module installed (for example, digital device emissions,

PC peripheral requirements, etc.).

In the event that these conditions can not be met (for example certain laptop configurations or co-

location with another transmitter), then the FCC authorization is no longer considered valid and the

FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and obtaining a separate

FCCauthorization.

7 Guidelines for Efficient and Safe Use

7.1 General

Read this information before using your OEM module

NOTE

Changes or modifications to the product not expressly approved by Phoenix Contact will void the

user's authority to operate the equipment.

7.2 Product Care

• Do not expose your product to liquid or moisture.

• Do not expose you product to extreme hot or cold temperature (see section Environmental for

further information).

• Do not expose your product to lit candles, cigarettes, cigars, open flames, etc.

• Do not drop, throw or try to bend your product since rough treatment could damage your

product.