User Manual

Data Sheet / User Manual RB-TW-2400

DataUserManual FCC_05.doc PHOENIX CONTACT

29/3

• Do not attempt to disassemble your product. Doing so will void warranty. The product does

not contain consumer serviceable or replaceable components. Service should only be

performed by Phoenix Contact.

• Do not paint your product as the paint could prevent normal use.

• If you will not be using your product for a while, store it in a place that is dry, free from damp,

dust and extreme heat and cold.

• The clearance and creepage distances required by the end product must be withheld when the

module is installed.

• The cooling of the end product shall not negatively be influenced by the installation of the

module when the module is installed.

7.3 Radio Frequency Exposure

The OEM Radio Board contains a small radio transmitter and receiver. During communication the

module receives and transmits radio frequency (RF) electromagnetic fields (microwaves) in the

frequency range 2400 to 2483,5 MHz. The output power of the radio transmitter is very low.

When using the OEM Serial Port Adapter, you will be exposed to some of the transmitted RF energy.

This exposure is well below the prescribed limits in all national and international RF safety standards

and regulations.

7.4 Electronic Equipment

Most modern electronic equipment, for example, in hospitals and cars, is shielded from RF energy.

However, certain electronic equipment is not. Therefore:

NOTE

This equipment emits RF energy in the ISM (Industrial, Scientific, Medical) band. Please insure that

all medical devices used in proximity to this device meet appropriate susceptibility specifications for

this type of RF energy.

7.5 Power Supply

The RB-TW-2400 must be supplied by a limited power source according to EN 60950-1.