Datasheet

RPI-BC 107,6 DEV-KIT KMGY
107161_en_00 13 / 13
PHOENIX CONTACT GmbH & Co. KG • Flachsmarktstraße 8 • 32825 Blomberg • Germany
phoenixcontact.com
• Note the orientation of the housing parts. The lower
housing part has an opening for the DIN rail connector,
which should be on the side of the upper housing part
that does not hold the Raspberry Pi.
• During insertion, ensure that the pin strip is not damaged
by the DIN rail connector.
• Place the lower housing part on the upper housing part.
The upper part slides on guides.
Alternatively, you can use a transparent housing cover which
can be reopened (BC 107,6 DKL S TRANS, 2896131).
• Turn the housing over.
• Put the cover on.
• Mount the base latch.
• The housing can be mounted directly on a wall or on a
mounting plate. Pull out the base latch as far as it will go
for mounting.
NOTE: You can no longer remove the cover
after installation.