Datasheet
RPI-BC 107,6 DEV-KIT KMGY
107161_en_00 PHOENIX CONTACT 11 / 13
6 Mounting the RPI-BC housing with Raspberry Pi
All parts latch together by hand. No tools are required.
• Place the upper housing part with the cover side on the
work surface.
• The removable fin is labeled in the upper housing part.
The fin can be removed if necessary.
• If you are using additional PCBs, insert them into the
upper housing part with the long side first.
• Insert the PCBs on the housing panel side first and then
pull them down.
When using a DIN rail connector, use a PCB that has an
appropriate pin strip on the left-hand side.
The Raspberry Pi A+ model is shorter than the other models.
If you are using the Raspberry Pi A+ model, you can use an
adapter. You can also use the housing without an adapter
with the A+ model.
• Insert the adapter. The adapter latches into the upper
housing part in three places.