Owner Manual MONOBLOCK AMPLIFIER RSd300.1 RSd600.1

RSd AMPLIFIERS
MONOBLOCK OWNER’S MANUAL
Phoenix Gold International, Inc. • 9300 North Decatur St. Portland, OR 97203 • 503.286.9300 • www.phoenixgold.com
3. REMOTE LOW PASS LEVEL CONTROL (LPL - SOLD SEPERATELY)
This port is for connecting the optional LPL Remote Lowpass Level Control
knob allowing up to 20dB of volume adjustment.
4. INPUT SENSITIVITY LEVEL CONTROL (SENS)
The input sensitivity level can be varied from 200 mV to 8.0 volts depending
on the output voltage of the source unit (refer to sub-section titled INPUT
SENSITIVITY ADJUSTMENT).
5. SUBSONIC FILTER
This is a filter to remove unwanted low frequencies that may cause damage
to the speaker or are inaudible. When this is used properly it will allow the
amplifier to run more effectively.
6. FREQUENCY SELECTOR (FREQ)
Allows variable adjustment from 40 to 400Hz
7. VARIABLE BASS BOOST
The bass boost will increase the output centered at 45Hz from 0 to 18dB
CONTROLS, INDICATORS, AND TERMINALS:
1. AUX OUTPUT (RCA)
This output is full range and can be used to connect to another amplifier for
system expansion.
2. LINE LEVEL INPUT (RCA)
To be connected to RCA pre-amp outputs from a source unit (i.e., radio,
tape deck or CD player).
RCA INPUT
CONTROLS