Installation Manual

24
Club Car Power Harness Installation
Note: Two Persons Should
be used to Remove Seat.
1. Remove Seat
2. Mount Power Supply
Bracket to cart.
Location is left side
3. Tighten screw for
Wedge
4. Remove Dash
Note: Use Steps 5 through
18
5. Remove screw caps
on the side of
dashboard, and save
6. Loosen screws
securing dashboard
7. Pop off top of
dashboard by running
screwdriver along the
top of dash and below
frame of cart
8. Bend top right corner
of dash inward to get
key switch assembly
out of dash
Note: DO NOT LET KEY
SWITCH COME IN CONTACT
WITH FRAME OF CART. IT
WILL BLOW THE FUSE TO
THE CART.
9. Run screwdriver along
bottom side of
dashboard to finish
removing
10. Clip a ½” x ½” notch in
the lower right corner
of the dashboard.
Note: This is to allow
enough clearance for the
power cable to be ran into
the bracket and attach to
the head unit.
A. Remove cap
B. Loosen scre
w
E. Insert screwdriver here to remove dash.
F. Run screwdriver along black line
C. Remove cap
D. Loosen scre
w