Installation Manual

25
11. Route Power cable
along frame of cart.
Secure with tie straps.
In predrilled holes.
12. Pull about 1’ 6” of
cable out to be ran for
the Display Unit.
Installation Tip:
Run power cable to corner
of compartment.
13. Insert bottom of
dashboard back into
place
Note: BE CAREFUL NOT TO
ALLOW THE KEYSWITCH
TO COME IN CONTACT
WITH THE CART FRAME.
14. Bend right corner
inward to allow key
switch room to be
inserted
15. Place left corner in
place
16. Push top part of dash
into place
17. Tighten screws
18. Replace caps
19. Attach Black wire to
cart ground and
secure with 5/16” lock
washer 5/16” nut.
20. Route Red and Blue
wire. Securing with tie
straps.
Note: The cable should be
isolated of working parts of
the cart.
Bend corner inward to get key switch past frame
Cable Length
Car
t
Ground Connection