User's Manual

5958
This device has been tested and found to comply with the requirements set up in the council
directive on the approximation of the law of member states relating to EMC Directive
89/336/EEC, Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC.
CE Statements
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
The radiated output power is far below the FCC Radio frequency exposure limits.
Nevertheless, this device should be used in such a manner that the potential for human
contact during normal operation is minimized.
Warning: Changes or modifications made to this equipment not expressly approved by the
manufacturer. May void the FCC authorization to operate this equipment.
Important! Please note the following:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Safety Statements
The manufacturer warrants that the Bluetooth Stereo Headset shall conform to her published
specifications, which may be subject to change, and remain free from defects in materials and
workmanship under normal, proper and intended use within warranty time, provide that proof
of purchase be furnished with any returned equipment.
During the warranty period, if any component part of the equipment becomes defective by
reason of material or workmanship, the manufacturer is immediately notified of such defect.
The manufacturer shall supply a replacement part or request return of equipment, freight
prepaid, and its designated facility for repair. In the event that no fault is found on a product
returned for repair, the manufacturer reserves the right to charge the customer its standard
published repair charge.
This warranty shall not apply to any product that has been subject to misuse, bending,
twisting, neglect, alteration, improper installation, operation outside of the parameters of the
published specification, use in any non-approved countries or unauthorized repair performed
by anyone other than a designated repair facility. Any non-warranty repairs or maintenance
shall be at the manufacture's standard in effect at the time.
This warranty is in lieu of all other warranties, whether expressed, implied, or statutory,
including but not limited to, implied warranties or merchantability and fitness for a particular
purpose. In no event shall the manufacturer be liable, whether in contract, in tort, or on any
other basis, for any damage sustained be its customers or any other person arising from or
related to loss of use, failure or interruption in the operation of any products, or delay in
maintenance, or for incidental, consequential, indirect, or special damages or liabilities, or for
loss of revenue, loss of business, or other financial loss arising out of or in connection with the
sale, lease, maintenance, use, performance, failure, or interruption of theses products.
Warranty
Copyright 1998-2005 Cellink Co. Ltd. All rights reserved. The Cellink logo is trademark of
Cellink Co. Ltd in Taiwan and may be registered in other countries. All other products are
trademarks or registered trademarks of their respective owners and hereby recognized as
such. All specifications are subject to change without prior notice.
Copyright and Trademark Notices
English English