User manual

Configuration and Diagnostics

7278_en_01 PHOENIX CONTACT 3-13

Trap configuration This part of the table is used to view or modify the IP addresses of the two trap receivers.

It is also used to activate/deactivate the "send traps" function.

"Software Update" Menu

This page is used to view or modify the parameters for a software update and to trigger the

update.

Figure 3-15 "Software Update" web page

3.2.4 Executing the Firmware/Software Update

Requirements

The device must have valid IP parameters so that the firmware can be updated. You also

need a functional Factory Manager or another TFTP server.

The following steps are required to update the software:

• Save the selected firmware/software in the download directory of your TFTP server. If

you use the Factory Manager, the path for a standard installation is as follows:

"C:\Programme\Phoenix Contact\Factory Manager\Version 2.3\download" or

"C:\Program Files\Phoenix Contact\Factory Manager\Version 2.3\download".

• Start the Factory Manager and check whether the TFTP server is activated.

Figure 3-16 Factory Manager with TFTPserver activated

• Start the WBM of the switch and call the "Software Update" page (...General

Configuration/Software Update).

• Enter the IP address of the computer on which the Factory Manager is installed in the

"TFTP Server IP Address" field.

• Then enter the complete file name of the firmware file in "Downloadable File Name",

but no path entries (no drive, no folder).

A suitable version of the Factory Manager can be downloaded at