Assembly and Maintenance Instructions

Changing Valve Connector
IMPORTANT: Be Sure Gas Supply Is
“OFF” Before Starting.
1. If your grill head is mounted on a column, the access
panel must be removed to expose the valve. (Fig. 3)
Fig., 3
Upward
Pressure
Access Panel
Fig. 4
Use 2 Wrenches
For All Gas
Connections
Regulator
Stainless Steel
Flex Hose
Special “T”
Connector
Fits All Grill
Valve
Positions
Valve Angles
to Left
Use 2
Wrenches
2. Loosen and remove the gas supply hose to the grill valve (in
the center of the control panel). Attach the special “T” con-
nector to the grill valve in the position shown then reattach the
gas supply hose to the “T” connector. Tighten securely using
two wrenches. Fig. 4
3. CAUTION: The system must be checked for leaks. Check
all connections with 50/50 solution of detergent and water
to see where bubbles appear. Retighten the connections.
NOTE: The
Flex Hose is
Factory
Assembly
to the
Burner
SearMagic Infrared Zone Cover
When Burner is in Use, Remove
and Hang on the Right Shelf
Infrared Burner Lighting Instructions
1. Always remove the cover before lighting.
2. Keep your head and body at least 1 foot away when
lighting the burner. Do not lean over an open burner.
3. Turn the burner on the “HIGH” position, and depress the
electronic igniter until the burner lights.
4. If the burner fails to light, turn control knob “OFF”, wait 5
minutes for gas to clear and try lighting again.
5. If the igniter doesn’t spark, check the gap between the
wire probe burner screen. It should be approximately
3/16 inches wide. If it is too small, the spark may be inef-
ficient. Gently readjust the wire probe as needed. If the
gap is normal, check the wire connections at the spark
module and igniter probes, located underneath the con-
trol panel.
6. If the igniter still doesn’t work, try replacing the battery.
Remove the collar around the igniter button by turning it
counter-clockwise. Replace the AAA battery, “+” side
down. Fig. 5
7. In the unlikely event these previous measures don’t
work, you can light the burner manually. Turn the burner
control knob to “OFF”. Remove the cooking grid from
above the burner and ignite a match. Place the match
directly on the burner screen, remove your hand from
above the burner and turn the burner control knob on
“HIGH”. Once the burner is lit, you can replace the cook-
ing grid.
Fig. 5
Push
Button
Spring
AAA Battery
+
Electronic
Ignitor
Infrared Care and Maintenance
1. After each use, remove the cover and light the burner on
“HIGH” and burner for 5 minutes. This will burn off any food
drippings and enhance the burner performance and increase
the burner longevity.
2. Never use water or liquid chemicals to clean the ceramic burn-
er. Burner may be damaged. Burner failure caused by im-
proper care and maintenance is not covered under war-
ranty.
3. If the burner develops ash over the surface, clean if gently with
a vacuum cleaner. Use a brush attachment so as not to dam-
age the burner.
4. If the burner should get wet, it is important to dry it out com-
pletely before attempting to use the burner. IMPORTANT:
Replace Cover When Burner Is Not In Use.
5. Never let anything heavy, hard or sharp fall onto the burner.
The ceramic is very fragile and can easily be damaged.