Product Manual

ManualsBrandsPhoenixRestorationEquip ManualsDehumidifiersPhoenix Restoration Equipment DryMAX LGR Dehumidifier — 80 Pints/Day, Blue, Xactimate Code: WTRDHM>

USEPHOENIX.COM

1.800.533.7533

The Phoenix DryMAX LGR Dehumidiﬁer

• LGR Capacity - Removes moisture even in dry

conditions for deep drying.

• Energy Efﬁciency - Removes 80 pints at AHAM while

drawing only 5.7 amps.

• Smallest Footprint Large Category Dehumidiﬁer.

• Slide Out Handle with Recessed Wheels for Easy

Maneuverability and Compact Storage.

• Integrated Cord and Hose Management for

Transportation and Storage.

• Bright, 4 Line Control Panel – Displays the Most

Common Readings without the Need for Scrolling.

• Status Light Indicator – Tell at a Glance What

Operating Mode the Unit is in.

• Integrated, Superior Stacking for Transportation and

Storage.

• 170 CFM - Optimized process air speeds drying and

provides static pressures for ducting.

• Plastic Housing - Rugged roto-molded housing resists

dents and scratches

• Outlet Ducting - 10” lay ﬂat exhaust.

• Pleated Media Air Filter – MERV 10

• Lighted cord - Easy to determine power to the unit.

The Phoenix DryMAX is 6% smaller than the closest

dehumidiﬁer and yet it still has an integrated handle and

wheels as well as onboard storage for the power cord and

condensate hose! The all-new Phoenix Micro-Channel

condenser allows us to pack so much performance into such

a small dehumidiﬁer.

The feedback on the stacking of the AirMAX was so positive

we made sure to build it into the Phoenix DryMAX.

We’ve also added a new four line display which provides you

with all the information you need to take readings directly

from the home screen.

A new Status Bar is located at the top of the new control

panel to give you instant feedback about the dehumidiﬁer

from across the room.

Remove only four fasteners and you have easy access to

service the unit.

TS-943

05/19 Rev. F

Phoenix DryMAX

Part No. 4036000 (RED)

4036060 (BLUE)

US Patent 7,194,870

Phoenix now offers

this unit in both

Red and Blue

Installation, Operation & Service Instructions

– READ AND SAVE THESE INSTRUCTIONS –

Speciﬁcations subject to change without notice.

4201 LIEN RD. • MADISON, WI 53704

Phoenix DryMAX - LGR Dehumidiﬁer

OWNER’S MANUAL

WISCONSIN

Summary of content (12 pages)

PAGE 1
4201 LIEN RD. • MADISON, WI 53704 Phoenix DryMAX - LGR Dehumidifier OWNER’S MANUAL Installation, Operation & Service Instructions – READ AND SAVE THESE INSTRUCTIONS – The Phoenix DryMAX is 6% smaller than the closest dehumidifier and yet it still has an integrated handle and wheels as well as onboard storage for the power cord and condensate hose! The all-new Phoenix Micro-Channel condenser allows us to pack so much performance into such a small dehumidifier.
PAGE 2
Table of Contents Introduction ................................................................................1 1. Safety Certifications ..........................................................2 2. Specifications .....................................................................2 3. Operation .............................................................................2 3.1 Transporting .................................................................2 3.2 Electrical Requirements......................
PAGE 3
.2 Electrical Requirements 3.3.3 Navigation The Phoenix DryMAX plugs into a common grounded outlet on a 15 amp circuit. It draws 5.7 amps at 80°F, 60% RH. If used in a wet area, a ground fault interrupter (GFI) is required. If an extension cord is required, it must have a minimum of 14 gauge conductors if 25 feet long or less and 12 gauge conductors if greater than 25 feet long. 3.3 Control Panel 3.3.
PAGE 4
3.3.7 Humidistat Mode Press the Set button to toggle the Humidistat Fan mode from Always On to Auto. Press the Next button to confirm selection and advance to the next screen. Light Bar = On The light bar colors and animations will persist while in Settings. 3.3.10 Humidity Units The default mode is Humidistat “Off” Press the Set button to toggle the Humidistat Mode On/Off. Press the Set button to toggle the humidity units between RH and grains.
PAGE 5
Light Bar = On The light bar colors and animations will persist while in Settings. Light Bar = On The light bar colors and animations will persist while in Settings. 3.3.12 Dew Point 3.3.15 About This Device The screen displays the ambient dew point. The following information is displayed on the About this Device screen: Device ID Hardware Version Firmware Version Press the Next button to advance to the next screen. 3.3.
PAGE 6
3.3.18 Diagnostic Mode - Float Switch 3.3.22 Diagnostic Mode - Display Test This display will communicate to the user the current status of the Float Switch. Press the Next button to advance to the next screen. Press the Set button to start the Display test. 3.3.23 Diagnostic Mode - Refrig. Test 3.3.
PAGE 7
3.5 Ducting A wire duct collar is supplied to allow 10” lay-flat duct to be attached to the Phoenix DryMAX outlet. Lay-flat plastic ducting is available; see section 6 Options and Accessories. To attach ducting to the wire duct collar, put the plastic duct end through the collar center and roll the duct end outward so that it overlaps the outside of the collar. The duct and collar may then be quickly attached to the Phoenix DryMAX by snapping the collar over the four exhaust tabs.
PAGE 8
4.2 Storage and Freeze Protection to the condenser coil. The refrigerant is cooled and condensed by giving up its heat to the air that is about to be discharged from the unit. The refrigerant liquid then passes through a filter/drier and capillary tubing which cause the refrigerant pressure and temperature to drop. It next enters the evaporator coil where it absorbs heat from the incoming air and evaporates.
PAGE 9
Unit removes some water but not as much as expected. 1. Air temperature and/or humidity have dropped 2. Humidity and/or temperature measurement is out of calibration 3. Defective defrost thermistor 4. Defective humidity sensor 3. 4. 5. 6. 7. Unit runs but does not pump water. 1. Hose kinked or plugged 2. Pump motor defective 3. Pump check valve plugged 4. Bad connection in pump circuit 5. Hose disconnected internally 6. Float switch 5.
PAGE 10
7 Wiring Diagram BLK (CORD) WHT (CORD) WHT-12 WHT-6 NEU 3 2 1 BLK-4 BLK-5 BLK-13 6 5 4 LINE RED-3 COMPRESSOR CAPACITOR YEL-2 POWER BOARD WHT-10 CONTROL BOARD TEMP/RH SENSOR RH-IN WHT-6 RH-OUT AUX EVAP FLOAT FLOAT SWITCH TEMP/RH SENSOR PRESS SWITCH THERMISTOR PROBE BLK-5 PUMP BLK WHT BLOWER BLK-13 BLOWER CAPACITOR BLK-11 BLK BRN-9 BRN WHT-10 BLU GRN COMP. YEL-2 BLK-4 RED-3 P/N 4036955 1.800.533.7533 USEPHOENIX.
PAGE 11
 8 Service Parts -      -      -                                         -        
PAGE 12
4201 LIEN RD. • MADISON, WI 53704 Phoenix DryMAX - LGR Dehumidifier LIMITED WARRANTY Warrantor: Therma-Stor LLC 4201 Lien Rd. Madison, WI 53704 Telephone: 1-800-533-7533 Who Is Covered: This warranty extends only to the original end-user of the Phoenix DryMAX dehumidifier and may not be assigned or transferred.